Konica Minolta KIP 3100 - Manual (Page 38)

Chapter 2 Basic Operation 2-18
2. 9 Dehumidifying the Roll Media
If the roll paper is extremely humidified, it may cause several kinds of defective prints.
The most common defective prints you will experience are “crease of paper” and “loss of image”.
Turn ON the Dehumidify Heater if the room air has too much humidity (65% or higher) to prevent
the above kinds of print defect.
You may be able to fix the above kinds of problem.
To turn ON the Dehumidify Heater, press the H side of the Dehumidify Heater Switch on the rear.
(Press its L side to turn OFF.)
Dehumidify Heater Switch
Normal Print
Normal Print
If the media is humidified;
If the media is humidified;
Crease of paper
Loss of image
NOTE
KIP 3100 is equipped with the Dehumidify Heater (optional for the US)
If needed, contact the service personnel for detail.
H (ON)
L (OFF)