Audiovox VOH1042 DL - Manual (Page 9)

CHANNEL TUNING SETUP
In order to easily access all available channels, it may
be necessary to perform the channel Auto-
Programming procedure whenever the vehicle’s
geographic location has changed, i.e. city-to-city,
weak signal area.
1. Press the AUTO MEMORY button on the remote
control unit or the AUTO PROGRAM (AP) button
on the flip down video unit. You will see the TV
cycle through all the channels. The built-in
microprocessor will automatically store each
channel that is actively broadcasting in your area.
(A) To tune only strong clear channels with the
CHANNEL UP/DOWN buttons, press the
SKIP/SEARCH button on the Remote Control
Unit until “SKIP MODE ON” is displayed on the
bottom of the screen. The TV will now tune
only to channels that are stored in memory
when the UP or DOWN buttons are used on the
monitor or the remote control.
(B) To tune to weak or marginal channels with the
CHANNEL UP/DOWN buttons, press the
SKIP/SEARCH button on the Remote Control
Unit until “SKIP MODE OFF” is displayed on the
bottom of the screen. The TV will tune to all
active channels when using the CHANNEL
UP/DOWN buttons or you can go directly to the
channel by using the 0-9 buttons on the Remote
Control.
2. To ERASE a channel, press the ERASE/WRITE
button on the Remote Control Unit until “MANUAL
MEMORY XX ERASE” is displayed on screen. To
STORE a channel, press the button until the
MANUAL MEMORY XX ADD is displayed on
screen.
TURNING THE VOH1042 DL ON AND OFF
1 Sliding the screen release lock forward will unlock
the screen and it will drop down slightly. (Pivot the
screen downward until a comfortable viewing angle
is reached). After the unit has been turned on and
is displaying a picture, adjustment to the viewing
angle can be made by pivoting the screen to
optimize the picture quality. The internal friction
detent will hold the screen in position while the
system is in use.
2 Pressing the power button on the pod or remote will
alternately turn the system on or off. When in use
the internal back lighting will illuminate the controls.
3 Remember to turn the unit off and pivot the display
screen to the locked position when not in use.
-8-