Altinex MT110-103 - Manual (Page 14)

MULTITASKER
400-0197-006 13
GROUP OPERATION
This command enables one or all outputs for all
cards in a group.
Command Format: [ONmGk]
m = Output number (m = # from 1-8)
Gk = Group number (k = # from 1-8)
Example:
Turn on Output 1 for all cards in Group 1 by
sending [ON1G1]. See the GROUP commands
for a detailed explanation.
PATH OPERATION
The path for outputs on the same or multiple
cards may be preloaded. This will set the path
for the output, but it is not active until the switch
command, [SW], is executed. Commands
ending in “P” are not executed immediately.
Command Format: [ONmCnP]
m = Output No. (m = # from 1 to 8)
Cn = Card ID (n = slot # from 1 to max slots)
P = Path
Example:
An MT110-103 card is in slot 4 and another in
slot 8. Enable Output 1 of C4 and Output 3 of
C8 simultaneously by sending the following:
[ON1C4P]
[ON3C8P]
[SW]
16. [OFF]
This command disables one or all outputs of a
single card or a group of cards.
SINGLE CARD OPERATION
Command Format: [OFFmCn]
m = Output No. (m = # from 1 to 8)
Cn = Card ID (n = # from 1 to max slots)
Example:
C4 has Output 1 turned on. The following
commands may be used to turn off the input.
1) [OFF1C4]: Turn off only Output 1.
2) [OFFC4]: Turn off all outputs.
GROUP OPERATION
This command disables one or all outputs for all
cards in a group.
Command Format: [OFFmGk]
m = Output No. (m = # from 1-8, * for all)
Gk = Group ID (k = # from 1-8)
Example:
1. [OFF1G1]: Turn off Output 1 for each card
in Group 1.
2. [OFFG1]: Turn off all outputs for each card
in Group 1.
PATH OPERATION
This command will set the path for the output,
but it is not active until the switch command,
[SW], is executed. Commands ending in "P" are
not executed immediately. The path for outputs
on multiple cards or the same card may be
preloaded.
Command Format: [OFFmCnP]
m = Output (m = # from 1 to 8, * for all)
Cn = Card ID (n = # from 1 to max slots)
P = Path
Example:
There are two MT110-103 cards in slots 4 and
8. Disable Output 1 of C4 and Output 3 of C8
simultaneously using the following commands:
[OFF1C4P]
[OFF3C8P]
[SW]