Konica Minolta bizhub 20P - Manual (Page 4)

3
● EU Directive 2002/96/EC and EN50419
This equipment is marked with the above recycling symbol. It means that at the end of the life of the equipment you must
dispose of it separately at an appropriate collection point and not place it in the normal domestic unsorted waste stream. This
will benefit the environment for all. (European Union only)
● IMPORTANT - For Your Safety
To ensure safe operation, the supplied three-pin plug must be inserted only into a standard three-pin power outlet that is
properly grounded through the normal household wiring.
Extension cords used with this printer must be three-pin plug type and correctly wired to provide proper grounding. Incorrectly
wired extension cords may cause personal injury and equipment damage.
The fact that the equipment operates satisfactorily does not imply that the power is grounded and that the installation is
completely safe. For your safety, if in any doubt about the effective grounding of the power, call a qualified electrician.
This product should be connected to an AC power source within the range indicated on the rating label. DO NOT connect it to
a DC power source. If you are not sure, contact a qualified electrician.
● Disconnect device
This product must be installed near an AC power outlet that is easily accessible. In case of emergencies, you must disconnect
the power cord from the AC power outlet to shut off power completely.
● LAN connection
CAUTION
DO NOT connect this product to a LAN connection that is subject to over-voltages.
● Wiring information (for UK only)
If you need to replace the plug fuse, fit a fuse that is approved by ASTA to BS1362 with the same rating as the original fuse.
Always replace the fuse cover. Never use a plug that does not have a cover. If in any doubt, call a qualified electrician.
- Warning - This printer must be earthed.
The wires in the mains lead are coloured in line with the following code:
Green and Yellow: Earth
Blue: Neutral
Brown: Live
(A32P-9560-00A)