Konica Minolta bizhub PRESS 1250P - Manual (Page 10)

R e v 1 .0 . . . .. . . .. . . . . .. . . .. . . .. . . .. . . .. . . .. . . .. . . .. . . .. . . .. . . 111111111111111 ‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘ ‘‘ J u ly . 2 0 1 2
5.2 INSTALLING ELEMENTS INTO THE GP-502
5. When installing additional elements into the
element drawer ensure that each set of
elements is aligned with the previous set.
Precise alignment is not required, yet severe
misalignment should be corrected.
The photo on the right shows an acceptable
amount of misalignment within the element sets.
6. Squeeze the handles of the element drawer
together and then push the drawer into the GP-
502. Always make sure to continue squeezing
the handles of the element drawer until after the
drawer is fully inserted into the machine. Failure
to squeeze the handles while inserting the
element drawer may cause element feeding
errors.
The illustrations below are shown on the GP-502 to aid in the installation of elements
10