Konica Minolta bizhub PRESS 1250P - Manual (Page 8)

R e v 1 .0 . . . .. . . .. . . . . .. . . .. . . .. . . .. . . .. . . .. . . .. . . .. . . .. . . .. . . 111111111111111 ‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘‘ ‘‘ J u ly . 2 0 1 2
2. Punch Chip Tray:
The punch waste tray contains the paper chips/waste that result
from punching holes in the paper. The tray will hold a maximum
of roughly 5,000 punches.
Before emptying the chip tray, wait until the printer and finishers
have finished operating, then open the front door and remove the
chip tray.
The GP-502 will alert the operator when the chip tray requires
emptying or when it is missing. The two illustrations on the right
show the images that the GP-502 screen will display when the
chip tray needs attention
.
To empty the chip tray first open the front door, then remove the
chip tray in a waste basket as shown in the illustration. Before
replacing the chip tray in the GP-502, remove any spilled paper
chips by using a vacuum cleaner. The emptied chip tray can now
be inserted into the GP-502 and the front door closed.
3. Element Feeder Drawer:
Before operating the GP-502 binding elements
must be installed into the element feeder drawer. For
detailed instructions on this process see section 5.2.
The GP-502 will alert the operator when the element
feeder drawer is empty or when it is open. See the two
illustrations below.
8