Konica Minolta Bizhub 215 - Manual (Page 85)

bizhub 215 6-8
6.2 Installing the fax driver 6
Settings for the machine
To use Port 9100 or LPR printing, you must configure the network settings for the machine in advance.
d
Reference
For details on the network settings, refer to [Network Setting] of [User's Guide Network Administrator], and
PageScope Web Connection - [Network] - [TCP/IP Configuration] and [Network] - [IPv4 Configuration].
Searching for a printer using the Add Printer wizard to install the fax driver
0 Administrator authority is required for installation.
0 Since the fax is searched for during the installation, be sure to connect this machine to the network be-
fore turning it on.
1
Insert the fax driver CD-ROM into the CD-ROM drive of the computer.
2
Click [Start], then [Control Panel].
3
Select the desired printer function in [Hardware and Sound].
% In Windows Vista/Server 2008, click [Printers] under [Hardware and Sound]. If [Control Panel] is dis-
played in Classic View, double-click [Printers].
% In Windows 7/Server 2008 R2, click [View devices and printers] under [Hardware and Sound]. If
[Control Panel] appears in the icon display, double-click [Devices and Printers].
4
On the toolbar, click the additional functions of the printer.
% Click [Add a printer] on the toolbar.
The [Add Printer] wizard appears.
5
Click [Add a network, wireless or Bluetooth printer].
Connected printers are detected.
% If no fax is detected, turn this machine off and on again.
In this case, turn off the printer, and then wait approximately 10 seconds before turning it on again.
If you turn this machine on immediately after turning it off, it may not function correctly.
6
Select your machine from the list, then click [Next].
% It may take some time to finish searching for all faxes.
7
Click [Have Disk...].
8
Click [Browse...].
9
Select the driver information file in a desired fax driver folder in the CD-ROM, then click [Open].
% Select a folder according to the operating system and language to be used.
10
Click [OK].
The [Printers] list appears.
11
Click [Next].
Items to be configured Description
IP address Specify the IP address of this machine in [Network Setting].
RAW port number To use Port 9100 printing:
Select PageScope Web Connection - [IPv4 Configuration], and en-
able the RAW port number (default: [9100]).
LPD Setting To use LPR printing:
Select PageScope Web Connection - [TCP/IP Configuration] -
[LPD Setting], and enable LPD printing.