Aspire Digital 2010 - Manual (Page 46)

Chapter 1 39
Suspend/Standby control Yes Yes Yes Yes
Electrical Specification
Supply voltage for LCD
display (V)
3.3 3.3 3.3 3.3
Supply voltage for LCD
backlight (Vrms) 690 690 690 690
AC Adapter
Item Specification
Vendor & model name Delta ADP-65DB
Liteon PA-1650-02CR
Input Requirements
Maximum input current (A,
@100Vac, full load)
1.5A [email protected]/100Vac and 240 Vac
Nominal frequency (Hz) 47 - 63
Frequency variation range
(Hz) 47 - 63
Nominal voltages (Vrms) 90 - 264
Inrush current The maximum inrush current will be less than 50A and 100A when
the adapter is connected to 100Vac(60Hz) and 240Vac(50Hz)
respectively.
Efficiency High efficiency 85% minimum, at 100~240Vac AC input, full load,
warm-up condition.
Output Ratings (CV mode)
DC output voltage
Offers constant voltage 19.0V output source with 65W max output
power capacity.
Noise + Ripple 300mvp-pmax (20MHz bandwidth) for resistor load
Output current 0 A (min.) 3.5A (max.)
Output Ratings (CC mode)
DC output voltage
18.0 ~ 20.0
Constant output 3.5A
Dynamic Output Characteristics
Start-up time
3 sec. (@115 Vac and 230Vac full load)
Hold up time 5ms min. (@115 Vac input, full load)
Over Voltage Protection
(OVP) 25V
Short circuit protection Output can be shorted without damage, and auto recovery
Electrostatic discharge
(ESD) 15kV (at air discharge)
8kV (at contact discharge)
Dielectric Withstand Voltage
Primary to secondary
4242 Vdc for 1 second
Leakage current 60uA at 240Vac/60Hz
Regulatory Requirements 1. FCC class B requirements (USA)
2. VDE class B requirements (German)
3. VCCI classII requirements (Japan)
LCD
Item Specification