Aspire Digital 2010 - Manual (Page 58)

51 Chapter 2
Security
The Security screen contains parameters that help safeguard and protect your computer from
unauthorized use.
The table below describes the parameters in this screen. Settings in boldface are the default and
suggested parameter settings.
Set Supervisor/User Password
If password on boot is required, the password must be set otherwise it cannot be enabled.
The formats of the password are as follows:
Length No more than 8 characters
Characters 0-9,A-Z (not case sensitive)
Parameter Description Option
Set User Password Press Enter to set the user password.
When set, this password protects the
BIOS Setup Utility from unauthorized
access. Length -- No more than 8
characters
Characters -- 0-9, A-Z (not
case sensitive)
Set Supervisor Password Press Enter to set the administrator
password. When set, this password
protects the BIOS Setup Utility from
unauthorized access.
Insyde Software SCU May 20, 2003 5:40:09
Main Advanced Security Boot Exit
Set Supervisor Password
Set User Password
Lock HardDisk Drive
Password On boot ------------Set Supervisor password----------------
Enter old Supervisor password: . . . . . . . . . .
Enter new Supervisor Password: . . . . . . . . . .
Verify new Supervisor Password: . . . . . . . . . .
OK Cancel
Enter new password. Password will NOT be displayed