Addonics Technologies DVD R/RW - Manual (Page 7)

DVD DigiCopier Switch Settings description
# Copy, Test, Test and Copy - after placing the source CD and a
Blank Disc into the target DVD±R/RW drive, the copy controller
will detect if the disc in the writer is a blank one. If it is a blank
disc, the copy controller will automatically begin copying after 5
seconds. If it is a rewriteable disc, the controller will erase first
then will proceed to copy.
During copying the DVD±ROM drive Eject key will be locked in
order to prevent failure. But the DVD±R/RW drive key is not lock,
so suspension is possible.
# Verify or Compare - after placing the source CD and a target
disc into the DVD±R/RW drive, the copy controller will detect if
the disc in the writer is ready. If it is, the copy controller will
automatically begin verification or comparison after 5 seconds. If
the disc is a blank one, both verification and comparison are
feasible but errors will appear after accomplishment.
# Erase - after a Rewriteable disc into the DVD±R/RW drive, the
copy controller will detect if the disc in the writer is ready. If it is,
the copy controller will automatically begin erasing after 5
seconds.
# Update Firmware – Copy the new firmware file onto a blank CD
and placing the disc with onto the DVDROM drive (top drive). If it
is ready, the firmware will be start updating after 5 seconds.
Addonics Technologies – DVD±R/RW DigiCopier Users Guide v1.0 6