Xerox WorkCentre M165-M175-3093 - Manual (Page 188)

Page 11-8 Quick Reference Guide
The Finisher does not staple or hole punch correctly
¾ For incorrect stapling, use less than 50 sheets of paper if the paper is heavier
than 20 lb.
L The maximum number of sheets is 20 when stapling heavyweight paper.
¾ Check the correct option has been selected on the Touch Screen.
¾ Check the Touch Screen for a fault message indicating no staples. Replace the
staple cartridge.
¾ When using large paper, remove any output contained in the stacker tray.
¾ Check that the Chad Bin is not full. The Chad Bin collects waste from the hole
punch. Refer to the Information and Training (CD2) for instructions.
¾ Check the correct paper size has been selected for the paper loaded in the tray.
¾ Check the paper tray guides are locked into position against the paper.
Output Quality
Stray marks or black marks from hole punched
originals are not removed
¾ Use the Edge Erase to erase the edge with the drilled holes.
¾ Copy from the document glass with the Document Cover down.
Images are out of sequence or upside down when the
Booklet Creation Feature is used
¾ Ensure that the originals are in the correct sequence.
¾ Feed LEF originals to SEF orientated paper stock.
¾ Enable the display options for Booklet Creation and ensure that the correct
sequence is selected (i.e.Left to Right or Right to Left).
The output is blank
¾ Ensure the originals are loaded either face up in the Document Handler or face
down on the Document Glass in the top right position.