AeroGarden PRO - Manual (Page 6)

Page 6
Reassemble Pump
With Grow Surface upside down, insert the Pump back into the
Pump Tower making sure that:
• The Rubber Feet of the Pump are facing up.
• The Face Plate is facing toward you.
• Pump is securely seated in the tube in the Pump Tower.
• The Pump Wire goes behind and underneath the Pump, and
lines up with Wire Slot.
A
Insert Cover Plate in the
bottom of the Pump Tower
and push down until all
corners snap in place.
Push Pump Wire back in
Wire Slot.
B
Turn Grow Surface right side up and place clean or new Filter back
in slots in front of the Pump. (If you do not have a Filter, please see
Troubleshooting on page 6.)
C
D
Replace Grow Surface in Bowl*.
Congratulations !
Your AeroGarden is ready for its next planting!
* If you cleaned your Pump to reduce noise, fill the Bowl with water and plug in
your AeroGarden. If the Pump is still noisy, please contact Customer Service.
If you are working with a planted AeroGarden, skip
step E (below) and proceed to final steps on page 7.
E
5