Alamo SL60 - Manual (Page 80)

ASSEMBLY
SL60 03/07 Assembly Section 3-2
© 2007 Alamo Group Inc.
ASSEMBL
Y
DEALER SETUP INSTRUCTIONS
Set up mower as received from factory with these instructions.
This mower is shipped partially assembled. Assembly will be easier if components are aligned and loosely
assembled before tightening hardware. Refer to bolt torque chart in Maintenance Section. All bolts are Grade
5 unless otherwise specified.
All references to location as right, left, front, rear, top and bottom is viewed facing the direction of forward travel
when the implement is properly attached to the operating power unit.
HITCH LINKAGE SETUP INSTRUCTIONS
IMPORTANT! For shipping purposes, the mower
hitch floating links are positioned to flex downward
toward the mower deck. Before operation, the
linkage must be re-configured to flex outward.
Failure to reposition floating linkage bolt and
bushing as described below before operation
could result in mower hitch failure.
1. Place the cutter on a solid level surface rest-
ing on its skids.
2. Remove lower bolt, nut and bushing which are
installed through both hitch link lower holes for
shipping purposes only as shown in top figure.
Never work under the Implement, the framework, or any lifted
component unless the Implement is securely supported or blocked up
to prevent sudden or inadvertent falling which could cause serious
injury or even death.
(SG-14)
Do not modify or alter this Implement. Do not permit anyone to modify or alter this
Implement, any of its components or any Implement function.
(SG-8)