Removing a barcode reader – ADIC 2 User Manual
Page 5
FastStor 2 Installing or Removing a Barcode Reader
5
Removing a Barcode Reader
Use the following instructions to remove a barcode reader from your autoloader. Use
Figure 4
as a
reference.
Figure 4
Removing a Barcode Reader
1
Turn off your autoloader, remove the SCSI cable(s) from the rear panel, and then disconnect the power
cord from the outlet.
2
The barcode reader is installed on the rear of the autoloader. Using a flat blade screwdriver, unscrew
the two screws that secure the barcode reader to the autoloader.
3
Unplug the barcode reader cord from the barcode outlet.
4
Replace the cover panel that you removed during installation (refer to
page 2) to the back of the autoloader, using the screws that secured the barcode reader to the
autoloader.
The cover panel prevents dust and other foreign items from entering the autoloader.
5
Reconnect the SCSI cable(s) and the power cord to your autoloader.
6
Store the barcode reader in a cool dry place.