Alloy Computer Products RNS5 - Manual (Page 17)

10. Power on the host, activate the Command Line mode, and ping the connected
Ethernet device to see if it will respond.
10.1 To enable the “Command Line mode”, click on Run in the Start menu,
type Command, and click on OK to continue.
10.2 Type ping 192.168.1.1 command to check the connection. Here we use
IP address 192.168.1.1 as an example.
11. Repeat step 10 to make sure that the connection of each device connected to
the RNS5/8 is successfully established.
15