Alloy Computer Products RNS5 - Manual (Page 14)

Wall Mounting
Follow the steps below to install the RNS5/8 with the wall mounting plate.
1. To remove the DIN-Rail clip from the RNS5/8, loosen the screws from the
DIN-Rail clip.
2. Place the wall mounting plate on the rear panel of the RNS5/8.
3. Use the screws to tighten the wall mounting plate onto the RNS5/8.
4. Use the hook holes at the corners of the wall mounting plate to hang the
RNS5/8 onto the wall.
5. To remove the wall mounting plate, reverse the steps above.
12