AVERATEC 2300 - Manual (Page 42)

Appendix B
40
System Recovery Software
No need to locate a recovery CD to restore your software settings, it is
already pre-installed on your notebook hard drive. Simply follow the
steps below and restore your notebook to the original factory settings.
Recovering your System from the Hard Drive
If you are creating Restore Points using Recover Pro 2004, recovering
your system from the hard drive will restore you system to the last
Restore Point created. If you are not creating Restore Points using
Recover Pro 2004, recovering your system from the hard drive will
restore your system as if it were a brand new system Any installed or
loaded software or data files wi ll not be recovered.
1. Turn your computer on and press F4 when the Averatec logo
appears.
2. Click Protect/Recover on left hand menu.
3. Click Phoenix FirstWare Recover Pro.
4. System restarts and will take 15 seconds until the next step is
displayed.
5. From Phoenix FirstWare Recover Pro Quick Start, click
Advanced.
6. From the next screen, click Factory Restore Point.
7. From the Recover Pro prompt, click Yes.
8. FirstWare Recover Pro will load.
9. Click Recover Entire Drive.
10. Prompt appears, click Yes.
11. Recovery begins.
!