AEG L75480WD - Manual (Page 17)

9.9 Setting the DELAY START
(button 9)
Press this button again an again to set
the required delay.
The display shows the set delay time val-
ue (up to 20 hours) for some seconds,
then it shows the duration of the pro-
gramme again.
Set the delay before you press the but-
ton 8.
You can delay the wash programme can
be delayed from 30 min - 60 min - 90
min, 2 hours and then by 1 hour up to a
maximum of 20 hours.
Adding items after you have set the
delay (throughout the delay time the
door will be locked):
• Press the button 8 to put the machine
in pause
• Add the laundry, close the door .
• Press the button 8 again.
Setting the delayed start:
• Set the programme and the required
options.
• Set the delay start.
• Press the button 8: the appliance
starts its hourly countdown.
The programme will start after the se-
lected delay has expired.
Cancelling the delayed start:
• Press the button 8 to set the washing
machine to PAUSE;
• Press the button 9 once until the dis-
play shows the symbol ’;
• Press the button 8 again to start the
programme.
You can change the set delay on-
ly after you set the washing pro-
gramme again.
The Delay Start can not be selected with
DRAIN programme.
9.10 Altering an option or a
running programme
It is possible to change some options
before the programme carries it out. Be-
fore you make any change, you must
press the button 8 to pause the appli-
ance.
Changing a running programme is possi-
ble only by resetting it.
Turn the programme dial to and
then to the new programme position.
Press the 8 button again to start the new
programme. The washing water in the
tub will not emptied out.
9.11 Interrupting a
programme
Press the button 8 to interrupt a pro-
gramme which is running, the corre-
sponding light starts blinking. Press the
button again to restart the programme.
9.12 Cancelling a programme
Turn the selector dial to to cancel a
programme which is running. Now you
can select a new programme.
9.13 Opening the door
When the machine is working and
through the delay time, the door is
locked.
If, for any reason, it is necessary to open
it, firstly press the button 8 to set the
machine to pause
If the light C after a few minutes goes
off, the door can be opened.
If the light C stays on and the door re-
mains locked, this means that the ma-
chine is already heating or that the water
level is too high. In this case the door
can not be opened.
If you cannot open the door but you
need to open it, turn the programme di-
al to
to switch the machine off. After
a few minutes the door can be opened
(pay attention to the water level and
temperature !) .
After closing the door, it is necessary to
set the programme and the options
again. Press button 8 to start the pro-
gramme again.
9.14 At the end of the
programme
The machine stops automatically. The pi-
lot light of button 8, the pilot lights A
and C go off. A blinking will appear on
the display.
If you have set a programme or an op-
tion that ends with water in the tub, the
light C remains lit. The door is locked.
ENGLISH
17