AEG L75480WD - Manual (Page 24)

5. When no more water comes out,
unscrew the pump cover (A) by turn-
ing it anti-clockwise and remove the
filter. Use pliers, if necessary.
Always keep a rag nearby to dry up
any water spillages when removing
the cover. Clean the filter under a
tap, to remove any traces of fluff.
6. Remove foreign bodies and fluff
from the filter seat and from the
pump impeller.
7. Check carefully whether the pump
impeller rotates (it rotates jerkily). If
it doesn’t rotate, please contact
your Service Centre.
8. Put the cap back on the emergency
emptying hose and place the latter
back in its seat.
9. Replace the filter into the pump by
inserting it correctly into the special
guides. Screw the pump cover firmly
by turning it clockwise.
WARNING!
When the appliance is in use and de-
pending on the programme selected
there can be hot water in the pump.
Never remove the pump cover during a
wash cycle, always wait until the appli-
ance has finished the cycle, and is emp-
ty. When refitting the pump cover, en-
sure it is securely re-tightened so as to
stop leaks and young children being
able to remove it.
13.7 The inlet hose filter and
the valve filter
It could be necessary to clean the filters
when:
• The appliance does not fill with water.
• The appliance fills with the water for a
long time.
• The indicator of button 8 flashes and
the display shows the related alarm.
Refer to 'Troubleshooting'.
WARNING!
Disconnect the mains plug from
the mains socket.
24 www.aeg.com