AEG MCC3881E-M - Manual (Page 29)

29 Installation
Connecting the appliance to the power supply
• The electrical outlet should be readily accessible so that the
unit can be unplugged easily in an emergency. Or it should be
possible to isolate the oven from the supply by incorporating a
switch in the fixed wiring in accordance with the wiring rules.
• The socket should not be positioned behind the cupboard.
• The best position is above the cupboard, see (A).
• Connect the appliance to a single phase 230 - 240 V/50 Hz
alternating current via a correctly installed earth socket.
• If the appliance is to be operated in a non-European country,
the supply voltage, current type and frequency of the appliance
indicated on the rating plate must correspond with the
specification of your power supply. The rating plate can be
found on the inside face of the control panel.
• The power supply cord may only be replaced by an electrician.
• Before installing, tie a piece of string to the power supply
cord to facilitate connection to point (A) when the appliance
is being installed.
• When inserting the appliance into the high-sided cupboard,
DO NOT crush the power supply cord.
• Do not immerse the power supply cord or plug in water or
any other liquid.
Electrical connections
WARNING!
THIS APPLIANCE MUST BE EARTHED
The manufacturer declines any liability should this safety measure not be observed.
• If the plug that is fitted to your appliance is not suitable for your socket
outlet, it must be cut off and the appropriate plug fitted.
• Remove the fuse from the cut off plug. The cut off plug should then be
disposed of to prevent the hazard of shocks in case it should be plugged into
a 13 Amp socket in another part of your home.
(A)