AEG Voxtel S100 - Manual (Page 29)

29
UK
t
Press
OK
and / to select your desired recall (flash) time (“SHORT”,
“MID”, “LONG”).
t
Press
OK
to confirm.
10.4.5 Change the system PIN code
A 4-digit system PIN code is used for changing the system settings of the
base station. It is
used to protect your phone against unauthorised use. The default system
PIN code is 0000.
t
Press and
/ to select “BS SET”.
t
Press
OK
and / to select “CHG PIN”.
t
Press
OK
and the display shows “OLD PIN?”.
t
Press
OK
and the enter the old system PIN.
t
Press
OK
,the display shows “NEW PIN”, press
OK
and enter your new
4-digit system PIN.
t
Press
OK
, the display shows “CONFIRM?”, press
OK
and enter your
new 4-digit system PIN again.
Note:
If the new PIN entered in step 6 is not the same as the new system PIN
entered in step 5, you must enter your new PIN at step 5 again.
t
Press
OK
to confirm.
10.5 Handset registration
Important:
When you purchase your phone, all handsets are already registered to
your base, so you do not need to register them.
Handset registration is only necessary when you buy extra handsets or if a
handset has become faulty.
You can register additional handsets to have up to 5 handsets per base
unit, with each handset‘s number (1 to 5) shown on its display.
t
Press and hold on the base station for more than five seconds, to
put the base station into registration mode. It will stay in registration
mode for about 1 minute, so the following handset sequence must be
completed within this time.
t
Press and
/ to select “REGISTER”.