AEG L61470BI - Manual (Page 29)

Make sure not to have more than a dis-
tance of 5.02 m (16.5 ft) between the ap- pliance inlet hose and the bottom of the
water storage tank.
Water-stop device
A
The inlet hose has a water stop device.
This device prevents water leaks in the
hose because of its natural ageing. The
red sector in the window «A» shows this
fault .
If this occur, close the water tap and
contact the service centre to replace the
hose.
13.5 Water drainage
There are different procedures to con-
nect the drain hose:
With the plastic hose guide.
• On the edge of a sink.
• Make sure that the plastic guide can-
not move when the appliance drains.
Attach the guide to the water tap or
the wall.
• To a stand pipe with vent-hole.
Refer to the illustration. Directly into a
drain pipe at a height of not less than
60 cm (23.6”) and not more than 100
cm (39.3”). The end of the drain hose
must always be ventilated , i.e. the in-
ner diameter of the drainpipe (min. 38
mm — min. 1.5”) must be larger than
the external diameter of the drain
hose.
ENGLISH
29