AEG T86585IH - Manual (Page 18)

HINTS AND TIPS
ECOLOGICAL HINTS
• Do not use fabric softener to wash
and then dry. In the tumble dryer
laundry becomes soft automatically.
• Use the condensate as distilled wa-
ter, e.g. for steam ironing. If it is nec-
essary clean the condensate before
(e.g. with a coffee filter) to remove
possible small pieces of fluff.
• Always keep the airflow slots on the
bottom of the appliance clear.
• Use the load volumes which are
specified in the programmes chapter.
• Make sure that is good airflow in the
appliance installation position.
• Clean the primary filter after each
drying cycle.
• Clean the heat exchanger filters
when the applicable indicator comes
into the view on the control panel.
• Spin good the laundry before drying.
AVERAGE LAUNDRY WEIGHTS
bathrobe 1200 g
quilt cover 700 g
man’s work shirt 600 g
man’s pyjamas 500 g
sheet 500 g
tablecloth 250 g
man’s shirt 200 g
night dress 200 g
pillow case 200 g
towelling towel 200 g
blouse 100 g
ladies’ briefs 100 g
men’s underpants 100 g
napkin 100 g
tea cloth 100 g
WATER HARDNESS AND
CONDUCTIVITY
Water hardness can be different for dif-
ferent locations. Water hardness has an
effect on the water conductivity and the
operation of the conductivity sensor in
the appliance. If you know the value of
the water conductivity you can adjust
the sensor to dry with the better results.
To change the sensor conductivity:
1. Turn the programme dial to availa-
ble programme.
2. Push at the same time 2 buttons
(see the illustration). Hold down un-
til one of the symbols come into
view on the display:
– low conductivity <300
μS/cm
– moderate conductivity
300-600 μS/cm
– high conductivity >600
μS/cm
3. Push the button again and again
until you set necessary level (see
the illustration).
4. To memorise the setting push at
the same time 2 buttons as are
specified in the point 2.
18