AEG A61900HLW0 - Manual (Page 28)

Problem Possible cause Solution
The lid is not shut properly or
do not close tightly.
Check if the lid closes well and
the gaskets are undamaged and
clean.
The temperature is not set cor-
rectly.
Set a warmer temperature.
The water drainage plug is not
correctly positioned.
Position the water drainage plug
in the correct way.
The lid doesn't close com-
pletely.
There is excessive frost. Eliminate excess frost.
The lid gaskets are dirty or sticky. Clean the lid gaskets.
Food packages are blocking the
lid.
Arrange the packages in the
right way, see the sticker in the
appliance.
The lid is difficult to open. The lid gaskets are dirty or sticky. Clean the lid gaskets.
The valve is blocked. Check the valve.
The lamp does not work. The lamp is defective. Refer to "Replacing the lamp".
It is too warm in the freez-
er.
The temperature is not set cor-
rectly.
Set a lower temperature.
The lid does not close tightly or
it is not shut properly.
Check if the lid closes well and
the gasket is undamaged and
clean.
Before freezing the appliance
was not precooled sufficiently.
Pre-cool the appliance for
enough time.
Large quantities of food to be
frozen were put in at the same
time.
Wait some hours and then check
the temperature again. Next
time insert smaller quantities of
food to be frozen at any one time.
Food placed in the appliance
was too warm.
Allow food to cool to room tem-
perature before storing.
Products to be frozen are
placed too closely to each other.
Place the products in a way so
that cold air could circulate
among them.
The lid has been opened often. Try to not open the lid often.
The lid has been opened for a
long time.
Do not leave the lid open longer
than necessary.
It is too cold inside the
freezer.
The temperature is not set cor-
rectly.
Set a warmer temperature.
The appliance does not
work at all. Neither cool-
ing nor lighting works.
Plug is not connected to the
mains socket properly.
Connect the mains plug properly.
28 What to do if…