Control panel, 1 switching on, 2 switching off – AEG A42200GSW0 User Manual

Page 22: 3 temperature regulation

Advertising
background image

3. CONTROL PANEL

0

1

2

3 4

5

1

Green Indicator Light

2

Red Indicator Light

3

Temperature Regulator

4

Half Loaded position

5

Full Loaded position

3.1 Switching on

1.

Allow the appliance to stand for 4
hours after installation.

2.

Insert the plug into the wall socket.

3.

Turn the Temperature Regulator
clockwise to the Full Loaded posi-
tion.

4.

The Green Indicator Light will light
up and remain lit until the appliance
is switched off at the mains.

5.

Leave to run for 4 hours to allow the
correct temperature to be reached
before placing food inside.
Yellow Indicator Light lights in the
switched-on state of the Freezer
Switch.

6.

The Red Indicator Light will also illu-
minate until the correct temperature
is reached.
A few hours after starting up the Red
Indicator Light will go out to show
that the correct temperature has
been reached for the setting chosen
and will stay out to indicate that ev-
erything is in order. It will come on if
the freezer temperature rises unduly
for instance, after opening the freez-
er door or placing food inside the

cabinet, but the light should go out
again when the temperature returns
to the correct storage level.

7.

When the appliance has reached the
set temperature (the Red Indicator
Light has gone out) adjust the Tem-
perature Regulator according to the
quantity of the stored foods.

3.2 Switching off

1.

To turn off the appliance, turn the
Temperature Regulator to the "O"
position.

2.

To disconnect the appliance from
the power disconnect the mains
plug from the wall socket.

3.3 Temperature regulation

The temperature within the appliance is
controlled by the Temperature Regula-
tor situated on the control panel.
To operate the appliance, proceed as
follows:
• turn the Temperature Regulator to-

ward lower settings to obtain the mini-
mum coldness.

• turn the Temperature Regulator to-

ward higher settings to obtain the
maximum coldness.

In case of freezing less food vol-
umes, the Half Loaded setting is
the most suitable.
In case of freezing much food
volumes, the Full Loaded setting
is the most suitable.

22 www.aeg.com

Advertising