Installation, 1 closing the door, 1 positioning – AEG A42200GSW0 User Manual

Page 27

Advertising
background image

Problem

Possible cause

Solution

Large quantities of food
to be frozen were put in
at the same time

Insert smaller quantities of
food to be frozen at any
one time.

Food placed in the appli-
ance was too warm

Allow food to cool to room
temperature before stor-
ing.

Products to be frozen are
placed too closely to
each other

Place the products in a way
so that cold air could circu-
late among them

It is too cold inside
the freezer

Temperature regulator
may be set incorrectly

Set a warmer temperature

The appliance does
not work at all. Nei-
ther cooling nor
lighting works

Plug is not connected to
the mains socket properly

Connect the mains plug
properly

Power does not reach the
appliance

Try connecting another
electrical device to the
power outlet

The appliance is not
switched on

Switch on the appliance

There is no voltage in the
mains socket (try to con-
nect another appliance
into it)

Call an electrician

The appliance does
not cool at all

Plug is not connected to
the mains socket properly

Connect the mains plug
properly

There is no voltage in the
mains socket (try to con-
nect another appliance
into it)

Call an electrician

The appliance is not
switched on

Switch on the appliance

8.1 Closing the door

1.

Clean the door gaskets.

2.

If necessary, adjust the door. Refer
to "Installation".

3.

If necessary, replace the defective
door gaskets. Contact the Service
Center.

9. INSTALLATION

WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.

9.1 Positioning

This appliance should be installed in a
dry, well ventilated indoor where the am-
bient temperature corresponds to the

ENGLISH

27

Advertising