AEG MMR 4133 - Manual (Page 26)

English
26
Overview of the components
1 button (Repeat)
2 / buttons (Scan forwards/backwards / next/previous
track)
3 CHARGE indicator
4
button (Play/pause)
5 Telescopic antenna
6 LCD sisplay
7 MEM button (save stations)
8
button (stop)
9 STANDBY button (standby/operating mode)
10
+/− volume control
11 AUX IN connector
12 DC 5 V
connector
13 USB connector
14 Memory card slot
15 ON/OFF switch
16 MODE button
17 PRESET button
18 Retractable handle
Accessories (without illustration)
Power supply
Installation
• Read the manual thoroughly before operating the de-
vice!
• Choose a suitable location for the device. Suitable loca-
tions are dry, even and antislip surfaces on which you may
operate the device easily.
• Make sure there is proper ventilation for the device!
• Remove, if necessary, the protection sheet from the
display.
Power supply (Adaptor)
• Insert the grid plug into a properly installed three prong
socket. Connect the device with the plug connector by
inserting its plug into the DC 5 V
jack of the
device.
• Make sure the grid voltage corresponds to the figures on
the rating plate.
CAUTION:
• Only use the supplied power adaptor for this device.
Do not use for other devices.
• Only use the original AC adapter. This adapter has
been specially designed for the built-in battery in order
to gradually charge the battery. Any other adapter can
shorten the battery life or can damage it or the device.
NOTE:
Disconnect from mains power supply during longer periods
of non-use.
Charging the battery
Before you can operate the device with the battery, you need
to charge it first.
1. Turn off the device by setting the ON OFF switch (15) to
the “OFF” position.
2. Connect the device to a wall socket with the power
adaptor. The CHARGE indicator (3) lights up red and the
battery is being charged.
Once the battery has been charged completely, the
CHARGE indicator turns green.
CAUTION:
Never leave the device unattended during the charging
process.
NOTE:
The duration of the charging process depends on the state
of charge of the battery.
General operation
Switch the device on/off
• Switch the device on by setting the ON OFF switch on
the back of the device to ON.
• Standby/operating mode: You may then toggle
between standby and operating mode by pressing the
STANDBY button (9).
• To switch off the device, set the ON OFF switch to OFF.
MODE button (16)
For switching between FM, AUX, USB and CARD mode.
NOTE:
The USB, CARD mode can only be selected respectively
when a respective storage medium is connected.
+/− Volume (10)
Adjust to your preferred volume level.
Listening to the radio
Scan stations
1. Repeatedly press MODE button (16) until the display
shows “FM”.
2. You have two options for tuning a station:
- Press the / buttons (2).
- Keep the / buttons (2) pressed. The device scans
to the next and the previous radio station respec-
tively.
3. If the reception is too weak and there is noise on the re-
ceived station, try to improve the reception by changing
the position of the telescopic antenna.