Bissell 7100 User Manual
Page 7
Air Flow Regulator
Open the air flow regulator by sliding the button
in the direction of the arrow to an open position
to reduce suction for fabrics such as draperies.
Close the air flow regulator by sliding the
button to the closed position for full suction.
Bag Change Indicator
If the bag change indicator turns to a red color
while you are cleaning, the dust bag needs to
be replaced. The bag may appear to be full or
only partially full depending upon the type of
debris picked up. Fine particles can block the
airflow in the bag and reduce suction before
the bag is full. If the bag change indicator
continues to display the red color even after
changing the dust bag, turn the vacuum off and
check for a clog in the hose or tools.
Storage Position
Located at the top rear side of the canister is
a nozzle support that can be used to park the
nozzle during pauses in cleaning, while
transporting the cleaner or while in storage.
Dust Bag Replacement
1.
Unplug the vacuum from electrical outlet.
2.
Open the dust bag compartment by lifting
up on the latch on the door at the front of
the canister.
3.
Lift out the bag holder and bag. Slide bag
out of holder and discard used bag.
4.
Slide new bag into holder. Place holder and
new bag into bag compartment making sure
entire bag is below seal gasket.
5.
Close dust bag compartment door and press
down gently until it locks into place.
O
perations
7
w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
2.
3.
M
aintenance and care
ug110-4001_7100_507.indd 7
ug110-4001_7100_507.indd 7
5/22/07 5:01:13 PM
5/22/07 5:01:13 PM