Olympus FL-36R - Manual (Page 37)

37
EN
Picture shooting using a digital camera
without communication capability
When using the electronic flash with a camera without communication
capability, adjust the ISO sensitivity and aperture value in AUTO mode
to the same values as on the camera or change the shooting distance
in MANUAL mode.
You can also emit the flash wirelessly as a slave flash.
g “Slave
flash” (P. 39)
AUTO
In this mode, the flash light intensity is controlled automatically
according to the aperture setting.
ISO
sensitivity Aperture
value
MODE button
1
While holding down the MODE button,
turn the dial to adjust the ISO sensitivity.
When 2 seconds pass with the MODE
button held, the camera enters custom
setup.
2
Press the ZOOM button to adjust the
firing angle according to the focal
distance of the lens.
3
Turn the dial according to the aperture
value of the lens.
If the ISO sensitivity/aperture value
combinations do not match the usable
range, the ISO sensitivity and aperture
value blink to alert you. In this case,
change the ISO sensitivity and/or aperture
value.
g “Light control range in AUTO
mode” (P. 46)
Press the TEST button to test the flash
activation.
g “Test flash activation” (P. 16)
4
When flash activation has been
performed correctly, the AUTO CHECK
lamp blinks for about 5 seconds after
the shutter is released.
ZOOM button
AUTO CHECK lamp
Flash intensity value
By selecting an ISO sensitivity and aperture value different from those set on the
camera, the flash intensity can be adjusted in 1/3 steps.
TEST button
r2067_e_000_cs2j.indb 37 r2067_e_000_cs2j.indb 37 2007/10/01 10:49:54 2007/10/01 10:49:54