Olympus EM10 - Manual (Page 38)

38 EN
Basic operations
5
Switching the information display
You can switch the information displayed in the monitor during shooting using the
INFO button.

When shooting using the viewfi nder
Monitor display
INFO INFO INFO INFO INFO INFO
Super control panel
250 250 F5.6
i
NORM
ISO
AUTO
AUTO
WB
AUTO
4:3
01:02:03 01:02:03
1023 1023
2014.01.01
R R Wi-Fi
Level gauge display
250 250 F5.6 P
Wi-Fi
Display OFF
Viewfi nder display
Can be switched while looking through the viewfi nder.
INFO INFO
Level gauge display
INFO INFO INFO INFO
250 F5.6 0.0 0.0 e e ISO-A 200 ISO-A 200
01:02:03 1023
INFO INFO
Image only
Histogram display Information display on
250 F5.6 0.0 0.0 e e ISO-A 200 ISO-A 200 01:02:03 1023
S-IS AUTO S-IS AUTO
250 F5.6 0.0 0.0 e e ISO-A
200
ISO-A
200
01:02:03 1023 250 F5.6 0.0 0.0 e e ISO-A
200
ISO-A
200
01:02:03 1023
L N
S-IS AUTO S-IS AUTO
FullHD FullHD
R R
 When shooting using Live View
INFO
Level gauge display
INFO INFO
250 250 F5.6 P 0.0 0.0
INFO
Image only
Histogram display Information display on
01:02:03 01:02:03
38 38 250 250 F5.6 0.0 0.0
R R Wi-Fi
L N
S-IS AUTO S-IS AUTO
ISO-A
200
FullHD
F
01:02:03 01:02:03
38 38 250 250 F5.6 P 0.0 0.0
R R Wi-Fi
L N
S-IS AUTO S-IS AUTO
FullHD FullHD
ISO-A
200
Histogram display
Display a histogram showing the distribution of brightness in the image. The horizontal axis
gives the brightness, the vertical axis the number of pixels of each brightness in the image.
Areas above the upper limit at shooting are displayed in red, those below the lower limit in
blue, and the area metered using spot metering in green.
Level gauge display
Indicate the orientation of the camera. The “tilt” direction is indicated on the vertical bar and
the “horizon” direction on the horizontal bar. Use the indicators on the level gauge as a guide.