Olympus PT-EP03 - Manual (Page 14)

EN 13
En
Seal the Case
1 Close the Case gently while aligning the mounting projection of the rear lid and groove.
2 Turn the open/close dial counter clockwise.
• The Case is sealed.
Check the operation of the loaded camera
After sealing the Case, check that the camera operations normally.
• Push the ON/OFF button on the Case and confirm that the camera turns ON/OFF.
• Turn the mode dial on the Case and confirm that the camera mode switches properly.
• Press the shutter lever on the Case and confirm that the camera shutter releases.
• Operate the zoom dial on the Case and confirm that the camera’s lens is controlled.
• Operate other control button on the Case and confirm that the camera functions properly as intended.
CAUTION:
• If the open/close dial is not fully turned, the Case will not be sealed. This will cause water leakage.
• Close the rear lid of the Case so that the lens cap or LCD hood strap doesn’t catch. If it catches, water leaks
may result.
Close
PT-EP03_EN.Book Page 13 Wednesday, October 13, 2010 11:28 AM