Olympus UFL3 - Manual (Page 24)

EN 23
EN
6. Using as Slave Flash
When using the flash with a camera that is not equipped with a wireless
RC flash function, use as a manual flash. Set the amount of light emission
manually.
1
Turn the mode dial to set “Manual”.
2 Turn the light level dial to set the light level (GNo.).
3 Setup the camera in the following way.
• Set cameras with slave mode to slave mode.
• Set cameras with manual flash emission mode to manual flash
mode. This setup will function also if you attach an external flash
with manual flash emission mode to the camera.
CAUTION
• The slave flash mode cannot be used with cameras that perform a pre-
flash because the electronic flash will be emitted simultaneously with the
pre-flash.
• If other photographers are shooting using flash, the electronic flash may
react to those lights and be emitted.
UFL-3_EN.book Page 23 Thursday, July 17, 2014 5:21 PM