Olympus UFL-2 - Manual (Page 24)

EN 24
EN
Shooting
When the flash is connected using the underwater fiber optic
cable
Following is an explanation of the basic method for taking pictures with the
flash connected to a camera’s underwater case using the underwater fiber
optic cable. Refer to your camera’s instruction manual for details about the
camera’s operation.
1 Press the MODE button on the flash repeatedly to set the flash to RC mode.
2 Set the camera’s RC mode to ON and set the camera’s built-in flash so as
to allow it to be emitted.
• Set the flash mode and the flash intensity on the camera.
3 While holding the MODE button pressed down, turn the dial to select the
channel and group.
Channel : Set the same channel, between 1 and 4, on the camera
and flash.
Group : You can control up to 3 groups (A, B and C) of flash arrays
with different flash modes and other settings. On the
electronic flash set in advance the group with which the
flash will be emitted.
4 Press the ZOOM button to adjust the firing angle.
5 After the shooting preparations are completed, take some test shots to
check the flash operation and the resulting images.
Channel
RC mode
Group
MODE button
r2090_e_00.book Page 24 Thursday, May 1, 2008 6:29 PM