Brocade Mobility RFS6000 Controller Installation Guide - Manual (Page 27)

Connecting USB devices
4
Brocade Mobility RFS6000 Controller Installation Guide 19
53-1001573-03
Connecting USB devices
The Mobility RFS6000 Controller contains one USB port for connecting USB flash
storage devices to the controller. The controller can use the USB flash storage
device for file transfers and firmware updates. Follow the setup instructions below
to connect the devices to the controller and then access those devices through the
Web UI or Command Line Interface.
1. Connect the USB flash drive to the USB .
2. Wait a few seconds for the drive to be recognized by the controller.
3. Follow the instructions in the Brocade Mobility RFS Controller System
Reference Guide or Brocade Mobility RFS Controller CLI Reference for more
information on accessing USB storage devices from the controller for file
transfers or firmware updates..
NOTE
The controller supports USB flash devices formatted with FAT or VFAT (FAT32)
filesystems only. If your flash storage device is formatted with another filesystem you
will need to format