Brocade Mobility RFS6000 Controller Installation Guide - Manual (Page 29)

Supplying power to the Mobility RFS6000 Controller
4
Brocade Mobility RFS6000 Controller Installation Guide 21
53-1001573-03
2. On the configuration computer, configure a terminal emulation application 
(such as HyperTerminal) as follows:
Supplying power to the Mobility RFS6000 Controller
1. Plug an approved AC power cord into the power connector at the back of the
Mobility RFS6000 Controller.
2. Plug the cord into a standard AC outlet with a voltage range of 100 to 240 VAC.
Terminal type VT-100
Port COM port
Terminal settings 19200bps transfer rate 
8 data bits 
no parity 
1 stop bit 
no flow control 
no hardware compression
sym_0
Rack mount
bracket
AC inlet