Pioneer A-20-K - Manual (Page 11)

Operation 04
11
En
English
Deutsch
Français
Nederlands
Italiano
Español
Ру
сский
Making an audio recording
You can make an audio recording from any audio source connected to the amplifier.
1 Select the source you want to record.
2 Start recording, then start playback of
the source component.
1
MENU
iPod

 
Music>
Extras>
Settings>
Shuffle Songs Backlight
/I STANDBY/ON STANDBY iPod/USB
5V 2.1A PURE AUDIO Hi-Bit 32 FUNCTION     NETWORK AUDIO PLAYER N-50
SACD/CD player
Network audio player
Turntable
Tuner
iPod dock, etc
Audio recording component
(CD recorder, tape deck, etc.)
Playback
Recording
SACD/CD NETWORK PHONO
TUNER AUX
To set for automatic standby status (Auto Power Down)
When this condition is set, if no input signal is detected for 30 minutes, the unit will automatically enter standby
status.
1 If the unit’s power is ON, hold the unit’s front-panel DIRECT button and LOUDNESS
button depressed simultaneously for three seconds.
When this condition is set to ON, the STANDBY/APD indicator on the unit’s front panel will light green. Press the
buttons again to disable the setting.
• This condition can also be set by means of the APD button on the A-30’s remote control.
• The factory default setting is ON.
Note
• Depending on the device connected, excessive noise produced by the device may be interpreted as an audio
signal, thus preventing the Automatic Power-Down function from operating.
Restoring all the settings to the factory default settings
1 When power is in standby mode, hold the front-panel’s DIRECT button and
SPEAKERS A button depressed simultaneously for five seconds.
2 Turn power ON to the unit.
A30_SYXE8.book 11 ページ ２０１２年３月６日 火曜日 午前１１時１３分