Pioneer BDP-450-K - Manual (Page 54)

08
54
En
Multi-channel sound is not
output. Is the audio output of the
connected AV receiver or
amplifier, etc., properly set? Read the operating instructions for the connected AV receiver or
amplifier and check the audio output settings of the AV receiver or
amplifier.
Is multi-channel sound
selected? Use the menu screen or AUDIO to switch the disc’s sound to multi-
channel.
Noise can be heard when
outputting DTS Digital Audio
signals from the
DIGITAL
OUT terminal.
Is the connected AV receiver
or amplifier compatible with
DTS Digital Surround? If an AV receiver or amplifier that is not compatible with DTS Digital
Surround is connected to the
DIGITAL OUT terminal, set Digital
Output to PCM (page 41).
192 kHz or 96 kHz digital
audio signals cannot be
output from the
DIGITAL
OUT terminal.
• Copyright-protected audio is converted to 48 kHz or less before
output.
• Set Downsampling to 96KHz or 192KHz (page 41).
Secondary audio or
interactive audio is not
output. Is HDMI Audio Out properly
set?
When listening to the sound from an HDMI OUT terminal, set HDMI
Audio Out to PCM (page 42).
Are Digital Output properly
set?
When listening to the sound from an DIGITAL OUT terminal, set
Digital Output to Re-encode or PCM (page 41).
Sound is fast or slow.
(Only for BDP-450)
When an HDMI cable is
connected, are audio signals
being output from devices
connected with cables other
than HDMI cables? When a Pioneer AV receiver or amplifier compatible with the PQLS
function is connected directly to the player’s
HDMI OUT terminal using
an HDMI cable, the PQLS function is activated when playing an audio
CD (CD-DA). Because of this, the sound output from components other
than the ones connected by an HDMI cable may be fast or slow. If this
happens, set
Control to Off (page 42).
After a disc is inserted,
Loading stays displayed and
playback does not start. Are there too many files
recorded on the disc? When a disc on which files are recorded is inserted, depending on the
number of files recorded on the disc, loading may take several dozen
minutes.
 is displayed in file names,
etc. The characters that cannot be displayed on this player are displayed in
.
A message indicating low
memory appears while
playing a BD-ROM disc. • Connect a USB device (page 22).
• Erase the data stored on the connected USB device from BUDA
Setup (page 45).
Problem Check Remedy
BDP-450_VXE8_IBD_EN.book 54 ページ ２０１２年６月２２日 金曜日 午後２時１１分