Pioneer AVH-P3400DVD - Manual (Page 41)

Making a call by entering
phone number
(Function of AVH-2400BT)
Wed 28 may
1 12:45 PM
ABCDEHGHI
012345678901
01
1 2 3
4 5 6
7 8 9
* 0 #
+ C
Off
Important
Be sure to park your vehicle in a safe place and
apply the parking brake when performing this op-
eration.
1 Switch to the entering phone number
mode.
Refer to Introduction of Bluetooth telephone op-
erations on page 24.
2 Touch the number icons to input the
numbers.
# Up to 24 digits can be entered.
3 Make the call.
Refer to Introduction of Bluetooth telephone op-
erations on page 24.
4 End the call.
Refer to Introduction of Bluetooth telephone op-
erations on page 24.
Note
Entering phone number mode cannot be oper-
ated unless a Bluetooth telephone is connected
to this unit.
Setting the private mode
(Function of AVH-2400BT)
During a conversation, you can switch to pri-
vate mode (talk directly on your cellular
phone).
Refer to Introduction of Bluetooth telephone op-
erations on page 24.
Using a cellular phone to
initiate a connection
(Function of AVH-P3400DVD)
A Bluetooth wireless connection can be estab-
lished from your phone by putting the unit into
initiating a connection mode.
You may need to refer to the operation manual
that came with your phone if you are unsure
how to initiate a connection from your phone.
1 Put the unit in initiating a connection
mode.
Refer to Introduction of Bluetooth telephone op-
erations on page 26.
2 Use a cellular phone to connect to this
unit.
# Operation varies depending on the type of cel-
lular phone.
# You may need to enter the link code on your
cellular phone to complete the connection.
Registering a connected
cellular phone
(Function of AVH-P3400DVD)
You can register a phone that is temporarily
connected to this unit in order to take full ad-
vantage of the features available with
Bluetooth wireless technology. Only one cellu-
lar phone can be registered.
1 Start registering a connected cellular
phone.
Refer to Introduction of Bluetooth telephone op-
erations on page 26.
2 Use cellular phone to register to this
unit.
If registration is successful, the device name
of the connected phone is displayed in the se-
lected assignment.
# If the assignment is already taken, the device
name will be displayed. To replace an assignment
with a new phone, first delete the current assign-
ment.
# If registration failed, the device name of the
connected phone will not be displayed in the se-
lected assignment. In such cases, return to step
1 and try again.
En
41
Section
11
Detailed
instructions
Detailed instructions