Pioneer AVH-P3400DVD - Manual (Page 61)

System settings
Switching the auxiliary setting
Activate this setting when using an auxiliary
device connected to this unit.
1 Display the system menu.
Refer to Introduction of menu operations on
page 43.
2 Touch AUX Input on the system menu
to turn AUX Input on or off.
Setting AV input
Activate this setting when using an external
video component connected to this unit.
1 Display the system menu.
Refer to Introduction of menu operations on
page 43.
2 Touch AV Input on the system menu to
turn AV Input on or off.
Setting the rear output and
subwoofer controller
This unit
’s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (
Full) or subwoofer
( Subwoofer) connection. If you switch the
rear output setting to Subwoofer, you can
connect a rear speaker lead directly to a sub-
woofer without using an auxiliary amp.
Initially, the unit is set for a rear full-range
speaker connection (
Full).
1 Turn the unit off.
Refer to Basic operations on page 10.
2 Press HOME to switch to the HOME dis-
play.
3 Touch System key.
System menu is displayed.
4 Touch Rear Speaker on the system
menu to switch the subwoofer output or
full-range speaker.
# When no subwoofer is connected to the rear
output, select
Full (full-range speaker).
# When a subwoofer is connected to the rear
output, select
Subwoofer (subwoofer).
Notes
! Even if you change this setting, there will be
no output unless you turn the subwoofer out-
put on (refer to Using subwoofer output on
page 45).
! Both rear speaker lead outputs and RCA rear
output are switched simultaneously in this
setting.
Setting the FM tuning step
! The tuning step remains at 50 kHz during
manual tuning.
1 Turn the unit off.
Refer to Basic operations on page 10.
2 Display the system menu.
Refer to Introduction of menu operations on
page 43.
3 Touch FM Step on the system menu to
select the FM tuning step.
Touching
FM Step will switch the FM tuning
step between 50 kHz and 100 kHz. The se-
lected FM tuning step will appear.
Switching sound muting/
attenuation
Sound from this system is automatically
muted or attenuated when a signal from
equipment with a mute function is received.
! Sound from this system returns to normal
when the muting or attenuation is can-
celed.
1 Display the system menu.
Refer to Introduction of menu operations on
page 43.
En
61
Section
12
Menu
operations
Menu operations