Pioneer PDP-435HDE - Manual (Page 20)

06 Preparation
20
En
Antenna cable - commercially available
If your outdoor antenna uses a 75-ohm coaxial cable with a standard DIN45325
plug (IEC169-2), plug it into the antenna terminal at the rear of the Media Receiver.
Basic connections
Connecting to an antenna
To enjoy a clearer picture, use an outdoor antenna. The following is a brief explanation of the types of connections that are used
for a coaxial cable.
Standard DIN45325 plug (IEC169-2)
75-ohm coaxial cable (round cable)
(commercially available)
Europe, except U.K.
and Eire
Europe, except U.K.
and Eire
U.K. and Eire
U.K. and Eire
SERVICE ONLY
i / o link.A SELECT INPUT 2 3
INPUT 2
INPUT 1
I N OUT CONTROL
INPUT 3
OPTICAL ANT
(DIGITAL) DIGITAL OUT
COMMON INTERFACE
SUB WOOFER OUTPUT INPUT 2
Y PB PR COMPONENT
MONITOR OUTPUT
R-AUDIO-L S- VIDEO VIDEO
BLACK
WHITE SYSTEM CABLE
AC IN
OUT IN
HDMI INPUT 3
SERVICE ONLY
i / o link.A SELECT
INPUT 2 3
INPUT 2
INPUT 1
I N OUT CONTROL
INPUT 3
OPTICAL ANT
(DIGITAL) DIGITAL OUT
COMMON INTERFACE
SUB WOOFER OUTPUT INPUT 2
Y PB PR COMPONENT VIDEO
MONITOR OUTPUT
R-AUDIO-L S- VIDEO VIDEO
BLACK
WHITE SYSTEM CABLE
AC IN
OUT IN
HDMI INPUT 3
Connecting the power cord
Plasma Display (bottom view)
Media Receiver (rear view)
SERVICE ONLY
i / o link.A SELECT INPUT 2 3
INPUT 2
INPUT 1
I N OUT CONTROL
INPUT 3
OPTICAL ANT
(DIGITAL) DIGITAL OUT
COMMON INTERFACE
SUB WOOFER OUTPUT INPUT 2
Y PB PR COMPONENT
MONITOR OUTPUT
R-AUDIO-L S- VIDEO VIDEO
BLACK
WHITE SYSTEM CABLE
AC IN
OUT IN
RF
OUT
IN
HDMI INPUT 3
PDP-505XDE/435XDE ONLY
• For viewing both analogue and digital broadcasts,
connect the antenna cable to the ANT OUT terminal
(antenna through out) and ANT (analogue input)
terminal.
• If “Aerial Power” setting is enabled, use an indoor
antenna with signal amplifier, 5V 30mA.
• Always turn off the main power of the Plasma Display and Media Receiver when connecting the power cords.
• Disconnect the power cord from the power outlet, Plasma Display and Media Receiver when the system is not going to be
used for a long period of time.
• For viewing analogue broadcasts only, connect the 75-ohm coaxial
cable (commercially available) to ANT (analogue input)
terminal.