Before installing the unit, Parts supplied – Pioneer AVIC70S User Manual
Page 7
Before installing the unit
• This unit is designed for vehicles with a 12-volt battery and negative grounding. Before
installing the system (especially in a recreational vehicle, lorry, or bus), check the bat-
tery voltage.
To prevent damage
• When disconnecting a connector, pull the connector itself. Do not pull the lead, as you
may pull it out of the connector.
Parts supplied
Connector
Pink lead extension cord
Power cord
Purple lead extension cord
RGB cable
No ACC position
Fig. 2
ACC position
Fig. 1
ON
S
T
A
R
T
O
FF
ACC
ON
S
T
A
R
T
O
FF
• When the unit is installed in vehicles
that do not have an ACC (accessory)
position on the ignition (as shown in
Fig. 2), be sure to connect the red lead
of the unit to the terminal controlled by
the ignition switch ON/OFF position. If
you do not, the vehicle battery may be
drained.
• Disconnect the negative (–) terminal of
the battery to avoid the risk of a short
circuit.
6
ENGLISH
ESPAÑOL
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS