Pioneer X-CM31DAB-K - Manual (Page 10)

Connections 03
10
En
Chapter 3:
Connections
CAUTION
• Be sure to turn off the power and unplug the power cord
from the power outlet whenever making or changing
connections.
• Connect the power cord after all the connections
between devices have been completed.
Speaker connection
To connect the speaker cord to the connector, insert into the
speaker connector of the rear of the receiver.
CAUTION
• These speaker terminals carry HAZARDOUS LIVE
voltage . To prevent the risk of electric shock when
connecting or disconnecting the speaker cables,
disconnect the power cord before touching any
uninsulated parts.
• Do not connect any speakers other than those supplied
to this system.
• Do not connect the supplied speakers to any amplifier
other than the one supplied with this system.
Connection to any other amplifier may result in
malfunction or fire.
• Do not attach these speakers to the wall or ceiling. They
may fall off and cause injury.
• These speakers are magnetically shielded. However,
depending on the installation location, color distortion
may occur if the speaker system is installed extremely
close to the screen of a television set. If this happens,
turn off the television set, and then turn it on after 15 to
30 minutes. If the problem persists, move the speaker
system away from the television set.
Connecting a TV
• When an iPod/iPhone is connected to this unit, the TV
output setting of iPod/iPhone is automatically set to
‘ON’.
Note
• Some iPod allow the TV output setting to be changed
while connected.
• When the iPod/iPhone is disconnected from this unit,
the iPod/iPhone’s TV output setting returns to its original
state.
ANTENNA
VIDEO LINE
AC IN
OUT IN
SPEAKERS
L
R
DAB/FM R L
Left
speaker
Right
speaker
This unit’s rear panel
VIDEO LINE
AC IN
OUT IN
SPEAKERS
L
R
R L
Yellow
TV
Video cable
(commercially available)
To video input
terminal
This unit’s rear panel
X-CM31DAB_VXE8_En.book 10 ページ ２０１３年４月８日 月曜日 午後２時３９分