Pioneer X-CM31DAB-K - Manual (Page 22)

USB playback 07
22
En
Chapter 7:
USB playback
Playing USB storage devices
It is possible to listen to two-channel audio using the USB
interface on the front of this receiver.
• Pioneer does not guarantee that any file recorded on a
USB storage device will play or that power will be
supplied to a USB storage device. Also note that Pioneer
will accept no responsibility whatsoever for loss of files
on USB storage devices caused by connection to this
unit.
1 Press USB as the input source.
“USB/IPOD” is shown on the main display.
2 Connect the USB storage device.
The number of folders or files stored on the connected USB
storage device appear on the main display automatically.
• This receiver does not support a USB hub.
• If iPod/iPhone/iPad is connected, the unit will begin
charging.
3 When the recognition is completed, press
 to start playback.
• When changing to a different input source, stop the USB
memory playback first before changing.
4 Disconnect USB storage device from the USB
terminal.
Turn the power off before removing the USB storage device.
Note
• This unit may not recognize a USB storage device, play
files or supply power to a USB storage device. For
details, see When a USB storage device is connected on
page 31.
• When a USB storage device is not playing and the unit
has not been operated for 15 minutes or more, the power
will automatically turn off.
Repeat play
Repeat play can play one track, all tracks or a programmed
sequence continuously.
To repeat one track:
Press REPEAT repeatedly until “RPT ONE” appears. Press
ENTER
.
To repeat all tracks:
Press REPEAT repeatedly until “RPT ALL” appears. Press
ENTER
.
To repeat desired tracks:
Perform steps 1 - 5 in “Programmed play” section on next
page and then press REPEAT repeatedly until “RPT ALL”
appears. Press ENTER.
To cancel repeat play:
Press REPEAT repeatedly until “RPT OFF” appears. Press
ENTER
.
Note
• After performing repeat play, be sure to press .
Otherwise, the file of USB storage device will play
continuously.
• During repeat play, random play is not possible.
Random play
The file of USB storage device can be played in random order
automatically.
To random play all tracks:
Press RANDOM repeatedly until “RDM ON” appears. Press
ENTER
.
To cancel random play:
Press RANDOM repeatedly until “RDM OFF” appears. Press
ENTER
.
Note
• If you press the  during random play, you can move
to the track selected next by the random operation. On
the other hand, the  does not allow you to move to
the previous track. The beginning of the track being
played will be located.
• In random play, the unit will select and play tracks
automatically. (You cannot select the order of the
tracks.)
• During random play, repeat play is not possible.
TIMER VOLUME
iPad
USB storage device
(commercially available)
X-CM31DAB_VXE8_En.book 22 ページ ２０１３年４月８日 月曜日 午後２時３９分