Pioneer AVX-7600 - Manual (Page 12)

11
Installation
DIN Front/Rear-mount
This unit can be properly installed
either from “Front” (conventional DIN
Front-mount) or “Rear” (DIN Rear-
mount installation, utilizing threaded
screw holes at the sides of unit chas-
sis). For details, refer to the following
illustrated installation methods.
Before installing the unit
• Remove the frame and the hold-
er. (Fig. 8)
Pull out to remove the frame and then
loosen the screws (2
× 3 mm) to
remove the holder. (When reattaching
the frame, point the side with a groove
downwards and attach it.)
Fig. 8
DIN Front-mount
Installation with the rubber bush
1. Decide the position of the side
brackets. (Fig. 9)
When installing in a shallow space,
change the position of side brackets. In
this case, stick conceal tape on parts
that protrude from the dashboard.
Fig. 9
2. Install the unit into the dash-
board. (Fig. 10)
After inserting the holder into the
dashboard, then select the appropriate
tabs according to the thickness of the
dashboard material and bend them.
(Install as firmly as possible using the
top and bottom tabs. To secure, bend
the tabs 90 degrees.)
• After installing the unit into the
dashboard, reattach the frame.
Fig. 10
Rubber bush
Screw
Dashboard
Side bracket
Screw (2
× 3 mm)
182
53
Holder
Conceal tape
Side bracket
Flush surface screw (5
× 6 mm)
Holder
Frame
Screw (2
× 3 mm)