Pioneer DEQ-P6600 - Manual (Page 11)

3 Touch or to select SUB WOOFER
(subwoofer).
Each time you touch or selects the
speaker in the following order:
FRONT (front speakers)CENTER (center
speaker)REAR (rear speakers)
SUB WOOFER (subwoofer)PHASE (sub-
woofer setting)
4 Touch to turn subwoofer output on.
# To turn subwoofer output off, touch .
5 Touch and then touch or to se-
lect the phase of subwoofer output.
Touch to select normal phase and
NORMAL appears in the display. Touch to
select reverse phase and REVERSE appears in
the display.
Note
When playing a 2-channel mono source with Pro
Logic B turned on, there may be occasions when
the following will occur:
! No audio is outputted if the center speaker
setting is SMALL or LARGE and no center
speaker is installed.
! Audio is heard only over the center speaker if
installed and the center speaker setting is
SMALL or LARGE.
Selecting a cross-over
frequency
If DVH-P7000R, DVH-P5000MP or AVH-
P6500DVD is connected to this unit, operation
is slightly different.
You can select a frequency, under which
sounds are reproduced through the subwoo-
fer. If the installed speakers include one whose
size has been set to SMALL, you can select a
frequency, under which sounds are repro-
duced through a LARGE speaker or subwoo-
fer.
1 Touch A.MENU and DSP and then touch
NEXT.
2 Touch CROSS OVER.
3 Touch or to select the speaker to
be adjusted.
Each time you touch or selects the
speaker in the following order:
FRONT (front speakers)CENTER (center
speaker)REAR (rear speakers)
SUB WOOFER (subwoofer)
# If DVH-P7000R, DVH-P5000MP or AVH-
P6500DVD is connected to this unit, you cannot
operate this procedure.
4 Touch or to select cross-over fre-
quency.
Each time you touch or selects cross-
over frequencies in the following order:
6380100125160200 (Hz)
Note
Selecting a cross-over frequency is to set a cross-
over frequency of the subwoofers L.P.F. (low-pass
filter) and that of the SMALL speaker H.P.F. (high-
pass filter). The cross-over frequency setting has
no effect if the subwoofer is set to OFF and other
speakers are set to LARGE or OFF.
Adjusting the speaker
output levels
You can readjust the speaker output levels
using a test tone while listening to music.
1 Touch A.MENU and DSP and then touch
NEXT.
Digital Signal Processor
En
11
English
Section
03