Pioneer XW-LF1-W - Manual (Page 16)

16
En
Note
• Pairing mode of the system is cancelled
at below condition.
- Can’t connect with Bluetooth device for
3 minutes.
- Push the Bluetooth paring button
again during pairing mode.
1 Press and hold Bluetooth
paring button for 1 second.
After that the POWER indicator blinks white
quickly and the unit will enter the pairing
mode.
Note
• When the system is turned on first time,
the unit goes to pairing mode
automatically.
2 Switch on the Bluetooth device
that you want to perform pairing
with, place the device within 1 m of
the system, and set it to the pairing
mode.
Pairing with the unit will begin.
• For more details, see also the operating
instructions of your Bluetooth device.
• If a list of supported device is shown on
the display of the Bluetooth device, you
will need to select “XW-LF1/LF3”.
• In case of entering PIN code, use “0000”.
(Only “0000” works for PIN code in this
product.)
3 When Bluetooth device has
connected, the POWER indicator
will change from blinking to
lighting.
4 Start playback of music
contents stored in Bluetooth device.
Connecting to a Bluetooth
device with which pairing
has been completed
1 Confirm that the POWER
indicator on the unit is blinking
slowly.
If the indicator is not blinking, but remains
lit, it means the unit is already connected to
a different Bluetooth device.
Operate the connected Bluetooth device to
disconnect it from the unit.
2 On the Bluetooth device that is
already paired with the unit, select
the unit from the Bluetooth list and
connect.
The name of the unit is shown as “XW-LF1/
LF3”.
3 Connection with devices is
successful, the POWER indicator will
change from blinking to lighting.
Operating range of Bluetooth audio is up to
10 m. (Measured in open space. Walls and
structures may affect range of device.)
LFA_En.fm 16 ページ ２０１４年５月１２日 月曜日 午後３時３９分