Pioneer DEH-P8400MP - Manual (Page 49)

Initial Settings
En 49
Adjusting initial settings
Initial settings lets you perform initial set up of
different settings for this unit.
1 FUNCTION display
Shows the function status.
1 Press SOURCE and hold until the unit turns
off.
2 Press OPEN to open the front panel.
3 Press FUNCTION and hold until CLOCK
appears in the display.
4 Press FUNCTION to select one of the initial
settings.
Press
FUNCTION repeatedly to switch between
the following settings:
CLOCK — FM — DAB — A-PI — WARN — D OPEN —
AUX — DIM — BRIGHT — ILL — SW — TEL1 —
TEL2 — DISP
Use the following instructions to operate each
particular setting.
• To cancel initial settings, press
BAND .
• You can also cancel initial settings by holding
down
FUNCTION until the unit turns off.
Setting the time
This is used to set the time on the unit’s clock
display.
1 Press OPEN to open the front panel.
2 Press FUNCTION to select CLOCK .
Press FUNCTION until the time appears in the
display.
3 Select the portion of the time display you
wish to set with
2/3.
Pressing 2/3 will select a portion of the clock
display:
HOUR — MINUTE
As you select portions of the clock display the
portion selected will blink.
4 Select the correct time with
5/∞.
Pressing
5 will increase the selected hour or
minute. Pressing
∞ will decrease the selected
hour or minute.
Setting the FM tuning step
Normally the FM tuning step employed by seek
tuning is 50 kHz. When AF or TA is on the tuning
step automatically changes to 100 kHz. It may
be preferable to set the tuning step to 50 kHz
when AF is on.
1 Press OPEN to open the front panel.
1
English
Español
Deutsch
F
rançais
Italiano
Nederlands
09
Section