Pioneer DCS-404K - Manual (Page 35)

35 Operation
4
Oper
ation
Radio Operations
Be sure that FM aerial is connected. (Refer to
the page 25)
Listening to the Radio
1. Press FUNCTION until FM appears in the
display window.
The last received station is tuned in.
2. Press and hold TUNE(-/+) for about two
seconds until the frequency indication
starts to change, then release. Scanning
stops when the unit tunes in a station.
or
Press TUNE(-/+) repeatedly.
3. Adjust the volume by rotating VOLUME on
the front panel or by pressing VOL + or - on
the remote control repeatedly.
Presetting the Radio Stations
You can preset 50 stations for FM.
Before tuning, make sure that you have turned
down the volume.
1. Press FUNCTION until FM appears in the
display window.
2. Select the desired frequency by using
TUNE(-/+).
3. Press PGM/MEM a preset number will flash
in the display window.
4. Press PRESET ( U/ u) to select the preset
number you want.
5. Press PGM/MEM.
The station is stored.
6. Repeat the steps 2 to 5 to store other
stations.
Deleting all the saved stations
1. Press and hold PGM/MEM for two seconds.
“ERASE ALL” will flash up on the unit display.
2. Press PGM/MEM to erase all of the saved
radio stations.
Improving poor FM reception
Press PLAY (B) (ST/MONO) on the remote
control. This will change the tuner from stereo
to mono and usually improve the reception.