Pioneer AVIC-F910BT - Manual (Page 37)

Setting the location as the
start point
When there is no route, only the starting point
can be set. Otherwise, the new route from the
starting point to the current destination will be
recalculated.
1 Touch [Route...] on the
“Map Confirmation Screen”.
2 Touch [Starting Point].
p When the cursor overlaps with a starting
point already set, it changes to [ Remove
Start]. All waypoints already set are
deleted.
Viewing information about
a specified location
Locating the cursor to your desired position
enables you to view detailed information about
the location by using the
“Map Confirmation Screen”.
1 Press the MAP button to display the na-
vigation map screen.
2 Touch and drag the screen to scroll the
map to the position you want.
3 Touch to display the
“Map Confirmation Screen”.
The
“Map Confirmation Screen” appears.
4 Touch [Info] at the bottom of the
“Map Confirmation Screen”.
The
“Point Info” screen appears.
1
2
1 The address and coordinates
2 Information about a nearby POI
p Up to 300 nearby POIs will be listed.
5 Touch or to scroll the nearby POI list
and then touch the desired POI.
Touching one of the listed POIs enables you to
view more detailed information about the POI.
6 Touch [OK].
If you touch [ OK], the
“Map Confirmation Screen” appears with a
focus on the selected POI.
Placing a map pin on the
location
The pin-shaped icons called
“map pins” can
be used just like markers. Placing the co-
loured pins on the map makes the position
stand out and helps you to find the position
easily later.
After the location is decided (Map Confirmation Screen)
Engb
37
Chapter
04
After
the
location
is
decided
(Map
Confirmation
Scree
n)