Pioneer CNDV-900HD - Manual (Page 11)

11
Instructions for upgrading
Instructions for upgrading This section describes the upgrade
procedures for your navigation system.
❒
The update has two phases.
Phase 1; Update the database
In this phase, take notice of the followings:
– All the functions other than AM and FM
are disabled during update. You can
perform simplified operations by using
the TRK (
4/6) button and VOL (2/8)
button. (We recommend changing the
AV source to AM or FM before you start
the update.)
– The update takes approximately 3 hours
in total.
– If you turn the ignition switch off (the
navigation system turns off) or eject the
upgrade disc, the update resumes when
the navigation system turns on or the
disc is reinserted.
Phase 2; Update the system
programme
In this phase, take notice of the followings:
– No functions are available.
– The update takes approximately 10
minutes.
– NEVER stop the engine of your vehicle
nor turn off the power supply to the
navigation system until the installation is
completed. Turning the power off in this
phase causes a malfunction or failure of
the navigation system.
Upgrade procedures
1. Park your vehicle in a safe place.
Leave the engine on, and make sure that the
handbrake is applied.
2. Press the MAP button to display the
current location.
Be sure to display the map of current position.
The updating cannot start at the other
screens, such as the scroll mode, the
navigation menu and AV screen.
Important notice:
For users who use AVIC-HD3II or use the
system upgraded to CNDV-800HD, updating
another software programme will begin first.
Note the same limitations written in Phase 2
when updating the programme.
MAN-CNDV-900HD-EN.fm Page 11 Monday, August 10, 2009 9:49 AM